Apr 29, 2016 - flush line to the lantern ring suitable for 125 PSIG suction pressures. Steel-Beam Clamps with Eye Nuts (MSS Type 28): For attaching to bottom of. Units, devices, and operator stations; and download from or upload to operator. Manual dimmers for fluorescent lighting shall be matched to suit the. Pull the burned out bulb upwards and towards the front of the Lantern Assembly. This will remove it. Replace with a new fluorescent 9 watt bulb. Snap the lens into place (bottom tab first) and replace the two screws. Carefully turn the screw clockwise to tighten. DO NOT OVER TIGHTEN screw. Dispose of burned out bulb in a.
Download Installation of GE Motion Sensing Diecast Metal Lantern None Home Safety Product for Free or View it Online on All-Guides.com.
Brand: GE
Category: Home Safety Product
Type: Installation for GE Motion Sensing Diecast Metal Lantern None
Pages: 2 (0.12 Mb)
OFFON
Pole Motion
The Single Pole Motion Sensing Switch detects motion toturn on
lights for an adjustable amount of time. A built-in photo cell can be set
to keep lights off when the lights aren't needed. The unit has excellent
sensitivity and a wide 150° detection range. It can be used with incan-
descent lighting as well as rapid start fluorescent lighting.
Installationis as easy as replacinga wall switch. However, some
codes require installation by a qualified electrician.
• 150° motion detection angle.
• Adjustable photocell.
• Works with incandescent and rapid start fluorescent lighting.
• Slide switch selectable OFF, ON AND AUTO modes.
WARNING: Turn power off at the circuit breaker before wiring.
• Remove the decorative coverplate (secured by two
• Remove Control Cover. (Press in with screwdriver.
• Remove the existing switch (if this is a retrofit
![Lantern Lantern](/uploads/1/2/5/7/125734901/667035015.jpg)
• Connect the detector as shown in the diagram.
Before installing the detector into the box, make
F
O
TO
• Mount the detector into the wall box with the mounting screws.
• For test purposes,use a small screwdriver to turn the time control fullycounter-clockwise and the light
control fully clockwise. Turn the power back on at the circuit breaker.
• Set the switch to the AUTO mode. When unit stabilizes (about 1 minute), the sensor is ready to detect motion.
If motion is detected, the lights will turn on. The lights will turn off 5 seconds after motion is no longer detected.
Plate Removed
Selection
++
(NEUTRAL)
junction box screw or
BLACK
BLACK
LIGHTING
GENERAL APPLICATION INFORMATION
The detector is more sensitive to motion across the front of the sensor than to motion towards the sensor.
The detector senses heat in motion and possible heat sources that change temperature quickly. Therefore, to
avoid false triggering, avoid placing the sensor where it will be aimed at air conditioners, heaters, and other
NEW APPLICATION
Choose a location where the motion sensor has a clear view of
RETROFIT APPLICATION
Motion sensing switch will replace existing wall switch.Use only
wherethe existing switch location provides a clear view ofthe
Included are: • The sensor switch • Cover plate • 3 wire connectors • 2 large screws • 2 small screws.
INSTALLING THE SWITCH
Typical Plan View of Coverage
15'
WARNING: For indoor use only.
Questions? Call 1-800-654-8483 Or visit us at www.jascoproducts.com